 |
d
Quick Connect Line Set Ends These
end fittings can be used to shorten or repair the 1/8" &
5/16" BD line sets. Swagelok
mechanical connectors are used to allow easy field installation.
$
15.00 ~ 1/8" line set end $ 15.00 ~ 5/16" line set end
|
|
Evaporator
fitting service tools
a These
fittings connect to the line set fittings.
R-134a quick connect gauge ports allow leak checking, evacuation,
and vapor charging of plates, without affecting refrigerant charge in the
compressor. $ 42.80 ~ service fitting tool (set of 2)
|
|
Installation of quick connect line set ends: Swagelok procedures
1/8"
line Installation: Clean tubing where you plan to cut.
Use a triangular file and score tubing 360 degrees. Carefully snap
tubing. Loosen nut slightly, but do not disassemble.
Insert tubing into fitting approximately 9/16" of an inch.
Finger tighten nut. Scribe nut and tighten using two wrenches, 3/4 of
a turn.
5/16"
line Installation: Clean tubing where you plan to cut.
Use a standard tubing cutter, cut slowly, do not de-burr.
Loosen nut slightly, but do not disassemble. Insert tubing into fitting approximately 5/8" of an
inch. Finger tighten nut. Scribe
nut and tighten using two wrenches, 1 and 1/4 turns.
Evaporator
fitting service tools connection:
Connect the Evaporator fitting service tools to the newly installed end
fittings. Use two wrenches and
tighten 1/8 of a turn past wrench snug. Connect service gauges.
Evacuate for 20 minutes with a high quality vacuum pump.
Break the vacuum with 134a refrigerant vapor only; this can go to maximum
bottle pressure. Leak check all
connections. Disconnect evaporator
fitting service tools. Cap all open
fittings. Evaporator is now
ready to connect to the to the condensing unit.
SEA FROST, 372
Route 4, Barrington, NH 03825 USA
Tel: (603) 868-5720 ~ Fax: (603) 868-1040
1-800-435-6708 (USA, Canada & Caribbean)
