ELECTRONIC THERMOSTAT AND THERMOMETER

• The Sea Frost ETT’s (Electronic Thermostat/Thermometer) accurate operating settings and the programmable differential increases efficiency.  In comparison, mechanical controls tend to over run the desired temperature range and must be set colder, running the compressor longer, to maintain the proper average temperature.    
  

• The ETT is powered by low voltage and will operate any Sea Frost electric system, AC or DC.

• The ETT always shows cabinet temperature, displayed in Centigrade or Fahrenheit.

• Accurate numerical setting of operating temperatures and differential makes set up and temperature adjustment easy. 

• Thermometer mode when operating dual systems.

• Wire leads allow mounting any distance from cabinet.

• Black faceplate with red LED operation indicators.

• Non-volatile memory, control will not loose settings.

The ETT is pre-wired with plug in connectors for the two 10’ probes and 15’ harness included.

The right hand rocker switch turns on the display. The left hand switch activates the control relay.  Red LEDs indicate ON and RUN modes. 

Faceplate size: 4 5/8” x 3 ½”  (120 mm x 90 mm). Requires 2 ½” (64 mm) behind mounting panel.  Weight 1 lb (.4 kilo).

Specify the voltage of the system to be controlled: 110 volts AC, 12 volts DC or 24 volts DC.

Electronic Thermostat and Thermometer Installation Manual

Pricing