These plates are also mounting high in the box. The box however is wider than the box in figure A.
A longer jumper line is required. Run the jumper line along the outboard edge of the box to keep the jumper line out of the way of the box opening.
Minimum distance from edge of the plate to
the outboard wall is 4 1/2" . This distance is needed for Quick
connect fittings and the bends in the tubing.
To order a system, the following information is require:
Plate dimensions and orientation. Both standard and custom plates available.
Location of valve on plate.
The distance between the two plates for the length of the connecting jumper line.
Liquid line length. (Distance between valve on the first plate in the series and the compressor.)
Suction line length. (Distance
between the second plate in the series and the compressor.)