Sea Frost Block

The Sea Frost block mounts high in the boat's ice box, to maximize air circulation. Taking up less space than 25 lbs of ice, the block utilizes otherwise unusable space. As little as 20 minutes of engine use is enough to create sufficient cold storage to make two trays of ice cubes. The block is ideal for single cabinet applications where ice making and refrigeration is desired. The block is shaped to fit under the counter overhang in a normally unusable section of the cabinet. (if the design of your cabinet does not allow this space due to full size lids or a very narrow design, one of our 809 plates should be used.)

• 30 to 40 minutes total daily running time in proper installations.

• Ice making with standard aluminum ice trays or while heeling with resealable plastic bags.

• Opportunity for isolated cold storage zone for pre-frozen foods and for rapid chilling of beverages, etc.

• Special corrosion resistant cast aluminum with a high conductivity heat path to provide the fastest cooling possible.

• Piping locations are varied to allow the best possible installations.

Sea Frost Plates

Sea Frost plates are available in many sizes. Custom modifications allow us to provide a part for any job. Measurements do not include mount tabs. Mount tabs add 1" on each side. Side or end tabs may be removed. Mount with 4 tabs.

• Tubing exits are located according to the plumbing requirements of the installation. Exits can be on the edges, back, or front.
• Corner cut plates are available.
• Plates can be fitted with equal sized coils for operation in combination with BG 1000 and Engine Drive.
• FREEZING POINTS: Standard for refrigeration. Low temp for freezers.
• Ice making with optional Sea Frost vertical ice tray system.
  

809 Plate

911 Plate

BMP Plate

12 x 12 Plate

Cut Corner Plate

Coffin Plate

SEA FROST, 372 Route 4, Barrington, NH 03825 USA
Tel: (603) 868-5720 ~ Fax: (603) 868-1040
1-800-435-6708 (USA, Canada & Caribbean)
e-mail: sales@seafrost.com