TRADEWINDS 12/24-VOLT DC

 

BDTW01.jpg (120276 bytes) BDTW02.jpg (348737 bytes) BDTW05.jpg (190331 bytes) BDTW04.jpg (230041 bytes) BDTW03.jpg (143769 bytes)

The Tradewinds is designed to be used with wind power, solar panels, and lots of battery back up. When fitted with the Engine Drive system it will extend the time between engine operation. Recommended for use with one holdover plate in a well insulated box. The TW has ducted air cooling and a water cooling option is available to allow the selection of air or water cooled operation.

Technical Data*

Tradewinds BD Tradewinds BDxp
Voltage 12 volts  12 volts
Fuse size 15 amps 30 amps
 Maximum amp draw (air 90° F.) 5.6 amps 7.7 amps
Draw@ medium speed  3.4 amps 5.4 amps
Draw @ low speed 2.6 amps 4.5 amps
BTUs @ max speed (ASHRE) (evaporator -10° F.) 250 BTUs 363 BTUs
Water pump (optional) .8 amps .8 amps

* For 24 volt operation, divide all amperage figures by half.

 


Remote Thermostat
Height: 3.5 inches; Width: 3.15 inches

The Remote Thermostat is panel
mounted. This control allows adjusting the
temperature or switching on/off of the Tradewinds 
without having to open the box. The thermostat
must be mounted within 50 inches of the cold
plate.  This thermostat standard on all Tradewinds
systems.



Electronic Thermostat/Thermometer
Height: 3.5 inches; Width: 4.6 inches

 

The Electronic Thermostat/Thermometer (ETT)
accurately controls the cold plate temperature as well
as displaying the interior cabinet temperature. LEDs
indicate
standby and run conditions.  The ETT
offers accurate operating settings. The programmable
differential increases efficiency.  Fitted with wired
sensors, the ETT control may be installed any distance
from the refrigerator cabinet. It requires 2.5 inches
behind its mounting panel. When ordering, specify
12- or 24-volt.


Speed Control

Height: 3.5 inches; Width: 3.15 inches

The Speed Control can be added to any BD/TW
system to change the compressor speed. Speed can
be adjusted for cooler weather and will reduce cycling
of the compressor. Slowing the compressor reduces
the cooling rate, lowering amp draw and reducing
battery wear. This also allows energy draw to be
matched to solar panels or windmill output. LEDs
indicate the compressor operation and speed. The
BD speed control should be used with the standard
thermostat or with the ETT. 

 


Speed Control with Thermostat
Height: 3.5 inches; Width: 4.6 inches

The Speed Control/Thermostat combines
the Remote Thermostat with a speed control. The
thermostat must be mounted within 50 inches of
the cold plate.


 

 

 

Price List

 TRADEWINDS KITS (To add to Existing Holding Plate Systems)

Tradewinds Air Cooled System 

1025.

Tradewinds XP Air Cooled System

1125.

Tradewinds Air/Water Cooled System

1240.

Tradewinds XP Air/Water Cooled System

1340.

TRADEWINDS AIR COOLED KITS (with evaporator plates)

Tradewinds Air Cooled Condensing Unit,  One 12" x 17" Stainless Steel Evaporator Plate

1450.

Tradewinds XP Air Cooled Condensing Unit,  One 12" x 17" Stainless Steel Evaporator Plate

1550.

Tradewinds Air Cooled Condensing Unit,  One 12" x 21" Stainless Steel Evaporator Plate

1500.

Tradewinds XP Air Cooled Condensing Unit,  One 12" x 21" Stainless Steel Evaporator Plate

1600.

Tradewinds Air Cooled Condensing Unit, Two 12" x 17" Stainless Steel Evaporator Plates

1875.

Tradewinds XP Air Cooled Condensing Unit, Two 12" x 17" Stainless Steel Evaporator Plates

1975.

Tradewinds Air Cooled Condensing Unit, Two 12" x 21" Stainless Steel Evaporator Plates

1975.

Tradewinds XP Air Cooled Condensing Unit, Two 12" x 21" Stainless Steel Evaporator Plates

2075.

TRADEWINDS AIR/WATER COOLED KITS (with evaporator plates)

Tradewinds Air/Water Cooled Condensing Unit,  One 12" x 17" Stainless Steel Evaporator Plate

1665.

Tradewinds XP Air/Water Cooled Condensing Unit,  One 12" x 17" Stainless Steel Evaporator Plate

1765.

Tradewinds Air/Water Cooled Condensing Unit,  One 12" x 21" Stainless Steel Evaporator Plate 1715.
Tradewinds XP Air/Water Cooled Condensing Unit,  One 12" x 21" Stainless Steel Evaporator Plate 1815.
Tradewinds Air/Water Cooled Condensing Unit, Two 12" x 17" Stainless Steel Evaporator Plate 2090.
Tradewinds XP Air/Water Cooled Condensing Unit, Two 12" x 17" Stainless Steel Evaporator Plate 2190.
Tradewinds Air/Water Cooled Condensing Unit, Two 12" x 21" Stainless Steel Evaporator Plate 2190.
Tradewinds XP Air/Water Cooled Condensing Unit, Two 12" x 21" Stainless Steel Evaporator Plate 2290.
Tradewinds kits are not pre-charged.  All kits include: remote thermostat panel kit, valve kit, receiver filter dryer, 134a refrigerant, and copper tubing. 

OPTIONS

Water cooling option for BD & TradeWinds Systems

215.

Water Pump (specify 12 or 24 volt)

160.

Remote Thermostat  (standard on Tradewinds kits)

65.

Electronic Thermostat Thermometer

350.

Compressor Speed Control Panel

55.

Compressor Speed Control Panel with Remote Thermostat

105.

Ice Tray Kit  (Two Stainless Steel Trays, Two Stainless Inserts, Mounting Rod & Clips)

95.

4" Vent Grill  (black or brown)

12.

4" Vent Hose, (price / foot)

2.50

BD/TW Bulkhead Mounting Bracket kit

20.

Prices are subject to change without notice.

 

 


SEAFROST, 372 Route 4, Barrington, NH 03825 USA
Tel: (603) 868-5720 ~ Fax: (603) 868-1040
1-800-435-6708 (USA, Canada & Caribbean)
e-mail: sales@seafrost.com